March 26, 2018
A good suspension system gives a vehicle a smooth, even ride while providing Kentwood drivers with good handling and control. But like any system on your vehicle, parts of the suspension system can wear out, leading to a lower ride quality and safety concerns. So it's a good idea for drivers in Kentwood to remember their suspension system in their schedule of preventive maintenance. Springs do most of the work of the suspension system. The most common types of springs are coil and leaf, but air springs and torsion bars are becoming more common. The body of the vehicle is “suspended” by the springs.
If springs were the only working component in your suspension system, however, you'd spend your travel time bouncing up and down like a bobblehead. That's where your shocks come in. They keep the rebound, or bounciness, of the springs under control. Shocks also keep your tires on the road, which keeps the driver in control of the vehicle. Some vehicles have struts in their suspension system. Struts are a compact combination of springs and shocks. They do the same job but in a single package.
Shocks wear out gradually, so it can be difficult for Kentwood drivers to notice when they need to be replaced. There's no definitive point when a vehicle's ride goes from "smooth and controlled" to "a bit imprecise." To check if your shocks or struts are worn, you should first do a visual inspection on them. If they are leaking fluid, they need to be replaced.
There are other less obvious signs that your suspension system needs attention. For example, an uneven, cupping wear on your tires may indicate that your shocks are worn. If your vehicle feels “floaty” when you turn, or, in other words, you don't feel that you have full control of the vehicle, you should check your shocks. Also, if the front end of your vehicle dips noticeably when you stop, it's time for new shocks.
Your owner's manual gives recommendations on how often the shocks should be checked, usually between 15,000 and 30,000 miles (24,000-50,000 km). If one of your shocks does need to be replaced, you should replace all four. This will keep your suspension even and ensure good handling of your vehicle. If you carry heavy loads, tow a trailer or drive on uneven Kentwood area terrain, you might also consider upgrading to a heavy-duty shock.
Regular shocks contain hydraulic fluid. The fluid helps them absorb the bumps or “shocks” of the road so the impact doesn't transfer to the vehicle's body. Premium shocks are filled with compressed nitrogen gas, which costs more but does a better job of controlling body motions. Regular shocks can develop air bubbles that reduce their effectiveness; the premium shocks don't have this problem. So if you want higher handling performance, if you drive off-road around Michigan or if you just want added comfort, you should consider upgrading to premium shocks or struts.
Replacing struts can put your vehicle out of alignment, so an alignment check should always follow this type of repair. Talk to your service advisor at Tuffy Kentwood (Kalamazoo Ave SE) in Kentwood for more information.
Tuffy Kentwood (Kalamazoo Ave SE)
4384 Kalamazoo Ave. SE
Kentwood, Michigan 49508
616.301.1436
November 17, 2024
When you start your vehicles engine, theres another motor that makes that whole process possible. Its called the starter, and its a small electric motor that gets your vehicle running. As you can imagine, its quite a chore for a little electric motor to turn over the big engine that powers you... More
November 10, 2024
You've probably never paid much attention to the writing on the sides of your tires, but they contain a wealth of information. There's a long combination of letters and numbers that can tell you a whole lot about what tires your vehicle was designed to be riding on. Let's check out this example... More
November 3, 2024
If your vehicles power goes to the rear wheels, then you have something called U-joints in the drivetrain. U-joints are connectors that allow the rotating power from your vehicles engine to deliver its power through a driveshaft to make the rear wheels rotate. You need U-joints because the surfa... More