July 5, 2020
Most Kentwood drivers are too young to remember life before power steering - cranking those great big steering wheels! It was a pretty good workout. Now power steering is standard. Let's look at how it works. The heart of any power steering system is its pump. The pump pressurizes the power steering fluid that provides assist for steering. Most pumps are driven by a belt that is run by the engine; a few are electrically powered. A high-pressure hose passes fluid from the pump to the steering gear. A low pressure hose returns the fluid back to the pump.
These hoses can develop leaks, so it is a good idea for Kentwood drivers to have them inspected at every oil change. Low fluid can damage the power steering pump. That is why power steering fluid level is on the checklist for a full-service oil change. The fluid needs to be compatible with the hoses and seals, so check your owner's manual for the right type - or just ask your friendly and knowledgeable pros at Tuffy Kentwood (Kalamazoo Ave SE) in Kentwood.
The fluid cleans, cools and lubricates the power steering system. It breaks down as the years go by and collects unwanted moisture, so Kentwood drivers need to replace it from time to time. Many vehicle manufacturers specify power steering service intervals. Unfortunately, this important service is sometimes left off the car maintenance schedule for many of us. So, when in doubt, every 25,000 miles/40,000 km or two years is a good fallback. Your technician at Tuffy Kentwood (Kalamazoo Ave SE) will use a detergent to clean the system, flush out the old fluid and replace it with the good stuff.
Here are some warning signs of trouble with your power steering: It's harder to turn the wheel, there's erratic power assist, you hear loud whining coming from the pump (which may be difficult to hear over the loud whining coming from the backseat), you have to top-off the fluid frequently, or you hear squealing belts. Remember to never hold the steering wheel to the far right or left for more than a few seconds at a time. That will wear out your power steering pump quickly.
Other steering components can be bent or damaged from wear or hard knocks: ball-joint, idler-arm, steering-gear, steering-knuckle and tie rod to name a few. Warning signs here are steering play, wandering, uneven tire wear and an off-center steering wheel. An annual alignment check at Tuffy Kentwood (Kalamazoo Ave SE) in Kentwood will reveal bent or damaged steering components.
Most SUV's, pick-ups and rear-wheel-drive cars need regular front-wheel-bearing service.
The bearings should be cleaned and inspected. If they are excessively worn, they need to be replaced. The bearings are then repacked in clean grease. The team at Tuffy Kentwood (Kalamazoo Ave SE) also recommends the wheel-seal be replaced when the bearings are serviced. Like everything else, check your owners' manual maintenance schedule. It's usually required around every two years or 40,000 miles/64,000 km. If you drive through water in the Kentwood area, the bearings will need service more often.
Tuffy Kentwood (Kalamazoo Ave SE)
4384 Kalamazoo Ave. SE
Kentwood, Michigan 49508
616.301.1436
November 17, 2024
When you start your vehicles engine, theres another motor that makes that whole process possible. Its called the starter, and its a small electric motor that gets your vehicle running. As you can imagine, its quite a chore for a little electric motor to turn over the big engine that powers you... More
November 10, 2024
You've probably never paid much attention to the writing on the sides of your tires, but they contain a wealth of information. There's a long combination of letters and numbers that can tell you a whole lot about what tires your vehicle was designed to be riding on. Let's check out this example... More
November 3, 2024
If your vehicles power goes to the rear wheels, then you have something called U-joints in the drivetrain. U-joints are connectors that allow the rotating power from your vehicles engine to deliver its power through a driveshaft to make the rear wheels rotate. You need U-joints because the surfa... More